1

Your cart is empty.

Custom Car Truck Motorcycle Boat Airplane Graphics

Decal Application Instructions

The application tape applied to your decals may have bubbled a little during shipping, this is due to temperature changes beyond our control. If so lay them on a flat surface and carefully squeeze out any air, this will ease application.

Larger decals such as ones designed for the windshield or hood may be applied easier by mixing a small amount of dishwashing detergent and water in a sprayer and wetting the sticky side of the vinyl and the surface which the decal is to be applied. This allows time to position the design correctly and remove any air bubbles using a squeegee or credit card.

 Step 1

Be sure the application area is thoroughly clean. Measure and place the sticker in the desired location. Put a piece of masking tape on the sticker to hold it in place.

Hint: For best results do not install the sticker in extreme heat or cold.

 Step 2

Lift the sticker up and peel the white paper backing off the sticker. Be careful not to pull the masking tape off.

 Step 3

Slowly lower the sticker and rub it in place with a credit card or similar item removing any air bubbles.

 Step 4

Wait a few minutes then slowly peel the application tape off at an angle. Be very careful not to pull the sticker off the surface. If the sticker pulls away from the surface repeat step 3.